TS-7680 kernel compile guide
For adding new support to the kernel, or recompiling with more specific options you will need to have an x86 compatible Linux host available that can handle the cross compiling. Compiling the kernel on the board is not supported or recommended. Before building the kernel you will need to install a few support libraries on your workstation:
Download and unpack the cross compiler:
|Note:||The cross compiler set up in the Cross Compiling section is 64-bit and can be used instead of the 32-bit cross compiler below. If using the aforementioned compiler, it is not necessary to install the 32-bit compatibility libraries as is it for the 32-bit cross compiler on a 64-bit Debian Jessie installation.|
wget ftp://ftp.embeddedarm.com/ts-arm-sbc/ts-7680-linux/cross-toolchains/imx28-cross-glibc.tar.bz2 tar xvf imx28-cross-glibc.tar.bz2 -C /path/to/folder/
/path/to/folder can be any directory so long as the current user has permissions to write to it. Remember this path as its used later during the kernel build procedure.
yum install ncurses-devel ncurses yum groupinstall "Development Tools" "Development Libraries"
sudo apt-get install build-essential libncurses5-dev libncursesw5-dev git u-boot-tools
If you are on a 64-bit system, then 32-bit libraries will be required for the toolchain, for newer Debian and Ubuntu distrubutions with Multiarch support, use the command:
sudo dpkg --add-architecture i386 sudo apt-get update sudo apt-get install libc6-dev:i386 zlib1g-dev:i386
On older distributions:
sudo apt-get install ia32-libs
For other distributions, please refer to their documentation to find equivalent tools.
Download sources and configure
git clone https://github.com/embeddedarm/linux-3.14.28-imx28.git cd linux-3.14.28-imx28/ # These next commands set up some necessary environment variables export ARCH=arm export CROSS_COMPILE=/path/to/folder/arm-fsl-linux-gnueabi/bin/arm-linux- # If using the 64-bit cross compiler from the Cross Compiling section, the following CROSS_COMPILE variable can be # used if the environment PATH is set up properly: # export CROSS_COMPILE=arm-linux-gnueabi- export LOADADDR=0x40008000 # This sets up the default configuration that we ship with make ts76xx_defconfig
Once you have the configuration ready you can make your changes to the kernel. Commonly a reason for recompiling is to add support that was not built into the standard image's kernel. You can get a menu to browse available options by running:
You can use the "/" key to search for specific terms through the kernel.
Build the kernel
Once you have it configured you can begin building the kernel. This usually takes about 5-10 minutes. This group of commands will also output a uImage file used by U-Boot on the TS-7680.
make && make uImage && make modules
We recommend running 'make' with the -jX argument, where X is the number of CPU cores+1 present on the build machine. This will greatly increase build speed.
Install the kernel/initramfs, headers, and modules
Next you need to install the kernel and modules to the SD card. We provide a simple script to copy the kernel uImage file, kernel modules, and headers to the SD card to update everything at once.
For example, if your workstation's SD card is /dev/mmcblk0:
If your workstation's SD card is /dev/sdc: