Difference between revisions of "TS-ETH10"

From Technologic Systems Manuals
(Added dimensions)
m (FTP links auto-updated (http://www.embeddedarm.com/documentation/ →‎ https://cdn.embeddedarm.com/resource-attachments/))
 
(2 intermediate revisions by 2 users not shown)
Line 8: Line 8:
|data1        = [http://www.embeddedarm.com/products/board-detail.php?product=TS-ETH10 Product Page]
|data1        = [http://www.embeddedarm.com/products/board-detail.php?product=TS-ETH10 Product Page]
|header2      = Documents
|header2      = Documents
|data3        = [http://www.embeddedarm.com/documentation/ts-eth10-schematic.pdf Schematic]  
|data3        = [https://cdn.embeddedarm.com/resource-attachments/ts-eth10-schematic.pdf Schematic]  
|header4      = Dimensions
|header4      = Dimensions
|data5        = 1.7" x 3.5"
|data5        = 1.7" x 3.5"
Line 23: Line 23:
=Jumpers and IRQs=
=Jumpers and IRQs=
{| class="wikitable"
{| class="wikitable"
! colspan="2" | I/O address selection
|+ I/O address selection
! I/O Address
|-
|-
! Add1
! Add1
! Add2
! Add2
! I/O Address
|-
|-
| Off
| Off
| Off
| Off
|
| 0x300
|-
|-
| Off  
| Off  
| On
| 0x300
|-
| Off
| On
| On
| 0x310
| 0x310
Line 55: Line 51:
|-
|-
| None
| None
| IRQ12
| 12
|-
|-
| IRQ5
| IRQ5
| IRQ5
| 5
|-
|-
| IRQ5
| IRQ6
| IRQ6
| 6
|-
|-
| IRQ7
| IRQ7
| IRQ7
| 7
|}
|}



Latest revision as of 20:41, 14 January 2021

TS-ETH10
TS-ETH10.jpg
Product Page
Documents
Schematic
Dimensions
1.7" x 3.5"

1 Introduction

The TS-ETH10 a PC/104 daughter card that provides one 10 base-T

  • Ethernet adapter running at 10 MBit.
  • I/O address and IRQ’s are jumper selectable (IRQ’s 5, 6, 7 & 12 available)
  • Cirrus CS8900 16-bit Ethernet chip with settings saved in EEPROM
  • Indicator LED’s for link and activity.
  • Linux , NetBSD and DOS drivers available.

2 Jumpers and IRQs

I/O address selection
Add1 Add2 I/O Address
Off Off 0x300
Off On 0x310
On Off 0x320
On On 0x330
IRQ jumper IRQ selected
None 12
IRQ5 5
IRQ6 6
IRQ7 7
Note: The 64Pin jumper allows TS-7000 (ARM) products to interface with the TS-ETH10 in 16-bit mode using an 8-bit (64 pin) connector. All other (x86) products require the full 104 pin PC/104 connector.

3 Product Notes

3.1 FCC Advisory

This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly (that is, in strict accordance with the manufacturer's instructions), may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class A digital device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference, in which case the owner will be required to correct the interference at his own expense.

If this equipment does cause interference, which can be determined by turning the unit on and off, the user is encouraged to try the following measures to correct the interference:

Reorient the receiving antenna. Relocate the unit with respect to the receiver. Plug the unit into a different outlet so that the unit and receiver are on different branch circuits. Ensure that mounting screws and connector attachment screws are tightly secured. Ensure that good quality, shielded, and grounded cables are used for all data communications. If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The following booklets prepared by the Federal Communications Commission (FCC) may also prove helpful:

How to Identify and Resolve Radio-TV Interference Problems (Stock No. 004-000-000345-4) Interface Handbook (Stock No. 004-000-004505-7) These booklets may be purchased from the Superintendent of Documents, U.S. Government Printing Office, Washington, DC 20402.

3.2 Limited Warranty

The manufacturer warrants this product to be in good working order for a period of one year from date of purchase. If at any time within the one-year warranty period this product should fail, the manufacturer will repair or replace the product, at its option. This limited warranty does not cover damages resulting from lightning or other power surges, abuse, misuse, or unauthorized modifications including units conformally coated by a third party. Technologic Systems' will pass through to Customer any transferable Product warranties, indemnities, and remedies provided to Technologic Systems' by the suppliers, including any warranties and indemnities for intellectual property infringement. To the extent permitted by law, Technologic Systems' makes no other warranty, express or implied, such as warranty of merchantability, fitness for purpose or non-infringement. Customer's sole remedies for breach of Technologic Systems' warranty are, at Technologic Systems' choice: (i) repair the Products; (ii) replace the Products at no cost to Customer; or (iii) credit Customer the purchase price of the Products.