TS-7100 Booting up the board

From Technologic Systems Manuals
Revision as of 10:03, 23 August 2019 by Kris (talk | contribs) (Fix process)

Power input to the TS-7100 is supplied via the power input connector, refer to that section for information on voltage ranges for this device.

Once power is applied to the whole device, there will be output on the debug console port. The following section of the manual provides information on getting the serial console connected.

U-Boot 2016.03-00393-g6be207d941 (Aug 22 2019 - 14:44:48 -0700)

CPU:   Freescale i.MX6UL rev1.2 at 396 MHz
Reset cause: WDOG
Board: Technologic Systems TS-7100
FPGA:  Rev 0x1
Silab: Rev 0x0
I2C:   ready
DRAM:  512 MiB
Net:   FEC0 [PRIME]

Press Ctrl+C to abort autoboot in 1 second(s)
starting USB...
USB0:   Port not available.
USB1:   USB EHCI 1.00
scanning bus 1 for devices... 1 USB Device(s) found
       scanning usb for storage devices... 0 Storage Device(s) found
No storage devices, perhaps not 'usb start'ed..?
Booting from the eMMC ...
** File not found /boot/boot.ub **
30986 bytes read in 103 ms (293 KiB/s)
5243424 bytes read in 352 ms (14.2 MiB/s)
NO CHRG jumper is set, not waiting
Kernel image @ 0x80800000 [ 0x000000 - 0x500220 ]
## Flattened Device Tree blob at 83000000
   Booting using the fdt blob at 0x83000000
   Using Device Tree in place at 83000000, end 8300a909

Starting kernel ...
Note: The "*** Warning - bad CRC, using default environment" message can be safely ignored when the unit is first booted. This means that no environment variables have been saved to disk, and U-Boot is falling back to the default. If "env save" is run, this will save the environment to disk, and this message will go away unless there is a further issue.

The default U-Boot boot process will check for USB updates before attempting to boot from on-board eMMC. Details about the bootup process, features, and other U-Boot information can be found in the U-Boot sections.